Windows 2008 and Replication

Rate This
  • Comments 2

I mentioned in a previous post that I would point out where SQL Server 2008 takes advantage of improvments in Windows 2008 (Check out the "Windows 2008" tag below for that). I just had to share something I got today from the replication team in an e-mail: 

 

"Windows Server 2008 includes a new networking stack, redesigned and rewritten from the ground up, with modern protocol implementations. Besides making IPv6 a full-fledged peer of IPv4, it supports better perf over high-latency, high-loss nets.

 

In [SQL Server 2008] Katmai, the DP & perf teams collaborated with Windows core networking, so SQL networking could take better advantage of the new stack. The impact of this work can be seen in just-completed replication testing, between two sites separated by over 2,000 miles.

 

The results are nothing short of eye-popping. A pull replication scenario, which used to run in 223 minutes using [SQL Server 2005] Yukon on Win2K3, takes just under 2 minutes on [Windows 2008 Server] Longhorn server with Katmai. And an 11.3GB snapshot was sent >2K miles in ~23 minutes, a rate of almost 500 MB/minute. That’s BYTES, not bits. Talk about “better together”!"

Leave a Comment
  • Please add 8 and 3 and type the answer here:
  • Post
  • Parece que los equipos de Windows y SQL han trabajado juntos para mejorar el rendimiento de las réplicas

  • SQL Server 2008 has not yet been released but nevertheless there are already some test results from the

Page 1 of 1 (2 items)