You’ve run the import wizard, and imported a bunch of tables into your tabular model. Now you want to import one more from that same connection. How do you do this?

What you need is the Existing Connections dialog. To start the Existing Connections dialog, go to Model->Existing Connections or click the Existing Connections button on the toolbar:

existing connections button

Either operation starts the Existing Connections dialog. Select the connection you want to reuse, then click Open:

existing connections open

This operation then takes you directly into the import wizard, as shown:

import wizard

Now you can import your table as shown.

If you forget to take this step, and simply import through the import wizard multiple times, connections will simply proliferate in the Existing Connections dialog, as shown:

multiple existing connections entries

Unfortunately, since you cannot change the connection used by a table after it has been created, you are stuck with these multiple connections forever unless you delete all tables associated with the “bad” connection and re-import them using the “good” connection.

Moral of the story – the Existing Connections dialog box is your friend, I know it is awkward to import from there (I trip over this too!) but you will learn to do it with practice over time.